Impact And Wear Resistant Ceramic Rubber Liners will form a strong and cushioning anti-wear layer, which greatly expand the usable range of alumina oceramics.
Advantages:
As vulcanization process is a very important, we have given full attentions to equipment and personnel to ensure that the rubber liners are flat, without ceramic protrusions or irregularities.
The rubber is made of high-quality natural rubber, which has high strength and toughness and reduces noise.
The surface of the ceramic sheet is dense and clear, does not absorb water, does not stick to the material, and the equipment carries a light load, which reduces the failure of transmission components and the consumption of spare parts.
The labor intensity of the operator is reduced, and there is no need to manually clean and excavate the sticky material of the mixer.
The rubber liner has a smooth surface, non-sticky material, and a service life of more than 30 months, ensuring safe production.
This kind of rubber liners are widely used in coal conveying and ash discharge systems in thermal power plants, and in metallurgical steel industry conveying, batching silos, hoppers, mixers, pelletizing discs and other equipment, which effectively solves the problem The problem of low service life of the batching conveying system due to large material drop, strong impact force and material bonding is solved.
At the same time, the The impact and wear resistant ceramic rubber liner can be twisted and cut, which is suitable for the installation of various special-shaped equipment.
In the installation process of the ceramic liner, the ratio of the ceramic glue is very important. The principle of mixing the glue is a small amount and multiple times.
It should be note that the mixed glue should not be exposed in the air for a long time, because it is easy to loss stickness.The ratio of two glue is 2:1, mix and stir well.
Special attention is that if the temperature is below to ten degrees, The glue should be heated and solidified, and the surface of the ceramic lining to be bonded and be heated to about thirty degrees, apply the glue to stick and heat until cured.
Our company's advantage:
1.More than 10 years of rich experience ensure high quality and consistency.
2. Special production process, excellent adhesion between ceramic and rubber, tiles will not fall off until the ceramic is worn.
3. We can provide customized rubber wear-resistant linings according to your requirements and drawings.
Hot Tags: impact and wear resistant ceramic rubber liners, China, manufacturers, suppliers, factory, wholesale, price, cheap, for sale, Shandong Qishuai, Ceramic Rubber Liner, Ceramic Lined Rubber Plates, Ceramic Rubber Lining Wear Plates, Rubber Backed Ceramic Lining Plate, Wear Resistant Ceramic Rubber Lining Plates, Wear Resistant Composite Rubber Linings